MultiDyne RGB-5000 Series - Manual (Page 7)

Instruction Manual, RGB5000 FTX/FRX 3BSPECIFICATIONS 7
SPECIFICATIONS
General:
Video Scan Rates:
15KHz -127KHz horizontal, 40Hz -130Hz vertical
Video Standards supported: RGBHV, RGBS, RGsB, VGA, SVGA, XGA, SXGA,
WXGA, WUXGA with TTL H and V syncs; Sun or Apple
with TTL composite sync; Silicon Graphics with Sync-
on Green; RGB HDTV 480i, 480p, 720p, 1080i or
1080p with TTL sync, YPrPb HDTV 480I, 480P, 720P
or 1080i with sync on Y including 3-level sync.
Video Resolutions Supported: 1920x1200 @ 60
Higher resolutions and/or refreshes supported with
some loss of sharpness
Video Signal to Noise Ratio: >60dB
Audio Signal to Noise Ratio: TBD
Fibers: 1 fiber, 62.5/125um Multimode (-2); 8.3/125um
Singlemode (-50/52)
Fiber Connector Type: ST
Wavelengths: 1310 and 850nm (-2); 1310 and 1550nm (-50/52)
Optical Budget: 6 dB (-2), 8 dB (-50), 13 dB (-52)
Maximum Transmission Distance: 200m (-2), 2km (-50) 15km (-52)
Operating Environment: 0 – 50 degrees C
Transmitter, RGB5000-FTX-2/50/52:
Video Input/Output Connectors:
1 HD-15 VGA plus 1 HD-15 VGA loop thru for local
monitor.
Video Input Impedance: 75 ohms (internal termination automatically removed
when Local Monitor is plugged in)
Video Input Level: 700mv p-p not including sync, if present on green
Audio Input Connector : 1, 3.5mm Stereo jack
Audio Input Level: Line level, not to exceed +4dB
Audio Input Impedance: >10k
Optical Output Power: -9 dBm (-2), -10 dBm (-50) or –5 dBm (-52)
Power Requirement: 5 VDC @ 1.6A
Receiver, RGB5000-FRX-2/50/52:
Optical Input Sensitivity:
-15 dBm (-2) or –18 dBm (-50/52).
Video Output Connector: 1 HD-15 VGA.
Video Output Impedance: 75 ohms
Video Output Level: 700mv p-p not including sync, if present on green
Audio Output Connector: 1 3.5mm Stereo Jack
Audio Output Level: Unity Gain with respect to FTX
Audio Output Impedance: < 100 Ohms
Power Requirement: 5 VDC @ 800mAmps
.
Specifications subject to change without notice.