NewHank Playmate - Manual (Page 4)

FACE PANEL FUNCTIONS
Figure 1
1. MIC INPUT-- Connect a microphone to this COMBO input that accepts either an XLR or a 1/4" Jack
connector.
2. INPUT SELECTOR -- Selects the input source to be routed to the corresponding channel. Inputs are
located on the rear panel.
3. PFL -- Sends pre-fader, post -EQ audio of the corresponding channel to the headphone monitoring
section and also the
VU meters and RCA output when (8) is engaged.
4. CHANNEL GAIN -- Adjusts the corresponding channel pre-fader and pre-EQ gain level.
5. CHANNEL EQ SECTION: CHANNEL TREBLE -- Adjusts the high (treble) frequencies of the audio on
the corresponding channel. CHANNEL MID -- Adjusts the mid-range frequencies of the audio on the
corresponding channel. CHANNEL BASS -- Adjusts the low (bass) frequencies of the audio on the
corresponding channel.
6. BALANCE -- Adjusts your left to right balance on both the RCA and XLR Master outputs.
7. STEREO / MONO -- When engaged your main master output will be MONO.
8. MASTER/PFL -- When engaged you see the pre fader cue signal(s) on the VU Meters. When raised
you see the post fader Master signal on the VU Meters.
9. LED VU METERS -- can indicate either the master output or cue channel input levels, depending on
the position of the MASTER PFL switch (8).
10. POWER SWITCH -- This is the main power ON/OFF switch. Before you turn the power on be sure
you have made all connections to the mixer. Also be sure your amplifiers are turned off. Remember
mixer on first and turned off last.
11. SD PLAYER & LCD -- This is the USB/SD Player, Controls, and LCD. The player and LCD will be
explained on page 6.
page 4
NEWHANK www.newhank.com Playmate Instruction Manual