NewHank Control USB - Manual (Page 4)

STOP - Press this button to stop the current track.
PLAY - Press this button to start the track .
NEXT TRACK -
PREVIOUS TRACK - Press this button to go back to the previous track.
Press this button to go to next track.
16. REPEAT BUTTON -Press this button to repeat the track.
17. AC CONNECTION - This connector is used to supply main power to the unit via the included
detachable power cord The power connection uses an I E C type connector use only the supplied
polarized AC power cord Use only a power cord that matches this type of connection Be sure to
only connect this unit to a power outlet that matches the printed power label on the unit Never use
a power cord when the ground prong has been removed or broken off The ground prong is used to
properly
. . . . , ,
. .
.
.
.
reduce the risk of electrical shock in case of an electrical short. This cord is designed to fit in one
direction only. Do not attempt to force a cord if it does not fit, be sure the cord is being inserted
18. BALANCED XLR MASTER OUTPUTS JACKS - The Master Output includes a pair of XLR
Balanced jacks as well as a pair of
. The 3-pin XLR jacks send a
balanced output signal. These jacks should be used when you will be driving an amp or other audio
equipment with a balanced input, or whenever you will be running a signal line greater than 15 feet.
Always, use these jacks whenever possible.
RCA Unba lanced Jacks (18)
19. AUDIO OUT R & L - The Master Output includes a pair as well as
a pair of RCA Unbalanced Jacks. The RCA jacks send a unbalanced output signal. Use these jacks
to send standard audio to a mixer or receiver. The red colored jack represents the right channel o-
utput and white jack represents the left channels output.
XLR Balanced Jacks (17)
20. LINE INPUT JACKS - CD players, Tape Decks and other line level instruments may
be connected to these jacks. The red colored RCA jack represents the right channel input
and the white represents the left channel input.Input volume will be controlled by channel
one fader.
B. MEDIA OPERATOR - REAR (FIGURE 2)
GENERAL Model: NEWHANK CONTROL USB, USB/SD Mp3 CONTROL PLAYER.
Type: SD Card and USB MP3 CONTROL PLAYER .
Installation: Place on flat surface or mount in flat 19 ” RACK
Power supply: Single Voltage:
AC 220V, 50Hz
Power consumption: 4.5W
Environmental conditions: Operational temperature: 5 to 35 C (41 to 95 F) ˚ ˚
Operational humidity: 25 to 85% RH (no condensation)
Storage temperature: -10 to 60 C (14 to 140 F)
˚ ˚
Accessories: Connecting RCA Cables
Please Note: All specifcations and improvements to and in the design of this unit and this manual
are subject to change at any time without any prior written or published notice.
SPECIFICATIONS
NEWHANK - www.newhank.com - CONTROL USB Instruction Manual Page 4
QUALITY AV PRODUCTS
QUALITY AV PRODUCTS
www.newhank.com
Mains power lead