NIStune Z32 ECU User Manual
Page 9
Advertising
Series 2
Series 2 has the FICD wire connected to pin 36.
Cut the track to isolate pin 33 so the EGT lamp does come on when the FICD activated.
Do this by cutting a track near D621 and C671. Cut it with a sharp blade several times,
being careful not to cut any other tracks in the area or yourself. Inspect the cut closely
using a magnifying glass to make sure there is no conduction in the track.
Cut Exhaust Temp Lamp
Note: This is located about 1.5cm up from the central 'hump' in the harness connector and
is near the large black driver IC's. IC611 and IC621.
Advertising