NIStune Type 3 - Manual (Page 9)

Type 3 Hardware Installation Manual Page 8 of 12
4. FIT BOARD TO ECU
Make sure that the socket on the board lines up correctly with the header pins.
5. FIT PACKING
Remove the self adhesive backing from the foam rubber strip and fit it to the lid so that the board will be held
firmly in position once the lid is fitted. This is best done by sitting the rubber strip (sticky side up) on top of the
Simtek chip which is in the middle of the board, and then carefully fitting the lid.
Congratulations – you now have a fully tuneable ECU!