Operating instructions, Suggested spread pattern – Ohio Steel 80TBS 80 lb. Broadcast Spreader User Manual
Page 5
Periodic Maintenance:
Tighten fasteners as needed before each use
•
Thoroughly wash spreader before storage
•
Before Using Broadcast Spreader:
Read all Safety Rules found on page 1.
1.
Make sure the drop holes in the bottom of the hopper are fully open with the
2.
Rate Control handle set on #30. If not, adjust control cable to allow for a
fully open hopper at position #30.
Obtain proper setting for material to be used from the Setting Matrix.
3.
Move stop bolt on range gauge assembly to proper setting.
4.
How to use Broadcast Spreader:
While moving forward, push control lever forward to the stop bolt. To stop,
1.
pull lever back to close flow holes before you stop moving.
When finished, empty any remaining material from hopper.
2.
FULL RATE SETTINGS
HALF RATE SETTINGS
SUGGESTED SPREAD PATTERN
4
Operating Instructions