OpenEye CM-512 - Manual (Page 46)

46
Preset Point
Select a preset point where the dome should go after the Return Time function is
activated. The preset point(s) should be set prior either in the PRESET setup menu or
through the keyboard.
•
Tour Line – Select a tour line that the dome camera should execute after
the Return Time function is activated. The tour line(s) should be set prior
either in the PRESET setup menu or through the keyboard.
•
Autoscan Line – Select an Auto Scan line that the camera should execute
after the Return Time function is activated. The Auto Scan line(s) should be
defined prior either in the AUTOSCAN setup menu or through the keyboard.
•
Pattern Line – Select a pattern line that the dome camera should execute
after the Return Time function is activated. The pattern lines should be
defined prior either in the PATTERN setup menu or through the keyboard.
Return Time
The camera starts to count down RETURN TIME when the camera idles, and then
execute the SELECT MODE function when the return time is up. The RETURN TIME
ranges from 1 to 128 minutes.
Go
You can execute the HOME function by selecting this item, if the HOME function is
enabled.
Exit
Exit the HOME SETTING menu. Then go to the MAIN PAGE 3 to continue
configuring your camera.