OpenEye CM-730 - Manual (Page 24)

24
5. Thread the power and Ethernet cables through either the side conduit entry or back
conduit entry. Then fasten the Dome Camera’s housing to the Electrical Box with the
two screws.
6. Connect the power and Ethernet cables to their connectors on the Dome Camera
unit.
7. Attach the snap-on module to the camera housing, and screw the module screw
tightly with the Security Torx to secure the camera module.
8. Use the OpenEye IP Finder software to locate the camera on the network and
complete configuration of the camera.
9. After connecting to the camera, adjust the camera's zoom level and focal length using
the zoom and focus ring screws.
10. Replace the inner dome cover.
11. Replace the dome cover, aligning the arrow mark on the dome cover with the one on
the housing.
12. Screw the two Torx screws on the side of the dome cover tightly to fasten the dome
cover.