Outbacker JOEY User Manual
Page 2
3. 80m operation is obtained by complete removal of the WANDER LEAD. It will also be necessary to use the
STINGER to adjust for lowest SWR on the desired operating frequency. You must adjust the STINGER for the
lowest SWR on 80m. With the STINGER set at the scribe point, the resonant frequency is approximately 3.850
MHz. To raise the resonant frequency, push the STINGER in. When operating the antenna on 6m, or 2m, the
length of the black WANDER LEAD (32") is a critical factor as it forms an integral part of the antenna tuning.
Its length should not be altered for any reason
TROUBLESHOOTING
EXTREMELY HIGH SWR- Check all connections for opens, or shorts. Make sure the WANDER LEAD extends from
the WL socket for your desired band of operation. Make sure the WANDER LEAD is evenly spaced as it wraps around
the antenna, counter clockwise, from the bottom up. Again, remember; do not wrap too tightly. Also, remember that a
quarter wave vertical needs a large span of metal/ground beneath it to act as a counterpoise. Try altering the position
of the counterpoise or use an earthing stake.
Remember there are more important aspects of mobile installations than having a 1:1 SWR. It is okay and fully
acceptable if your SWR should vary from 1:1 to 2:0. Pay special attention to grounding and antenna placement.
CARE AND MAINTENANCE
NB: The Outbacker Joey antenna is not to be used as a mobile vehicle antenna. Stationary use
only.
All OUTBACKER antenna are fitted with a rubber "O" ring inside the tip to prevent water entering the mainshaft,
however condensation will accumulate on the inside of the shaft, do not be alarmed. This condensation will not harm
the antenna, nor will it cause inferior performance. Just remove the KNURLED LOCKING NUT and shake out any
water. Check your antenna after heavy rain.
To clean your antenna, wash it with warm, soapy water and wipe dry with a soft cloth. Apply a thin coating of non-
abrasive car wax. Buff the antenna to a shine. Do not use cleaners with an acetone base, as this will strip the shiny
coating.
SPECIFICATIONS
Model: Joey (Cut to American frequencies not for resale outside N
orth America)
Band Coverage: 80m-75m-40m-30m-20m-17m-15m-12m-10m-6m-2m
Feed Impedance: 48-52 Ohms
Power: 20 watts (pep)
Construction: Brass - Stainless Steel - Urethane, 1/4 wave helical.
Mounting: PL259 (UHF) plug (brass)
Wander Lead Length: 32" Plug tip, to Plug tip.
Supplied with Joey antenna
Qty___
_PaH#_____ Description
1 x
Main shaft. (Black)
1 x
OBWL Wander lead. (WL stands for Wander Lead, 32" in length)
1 x OBSP15 15" tuning spike
Should you discover your OUTBACKER antenna has been damaged in transit, please notify your supplier, or write to the manufacturer
within seven days. Claims made more than 7 days after delivery -will not be recognized.
OUTBACKER NORTH AMERICA, INC
214 Second Street
MANCHESTER KY 40962
Phone (606)598-2029
Fax (606)598-4413
OUTBACKER! the renowned HF Amateur Mobile Antenna - bridging the gap in worldwide communications.