Lektron series, Rechargeable battery installation, Battery handling instructions battery installation – Paso Sound SL370K User Manual

Page 7

Advertising
background image

PAGE 7

SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE

Lektron Series

®

PROFESSIONAL AUDIO & SOUND

®

IMPORTANT BATTERY NOTE

The PASO 27/12 Battery is U.L. and I.A.T.A. approved and manufactured
in an ISO 9002 Certified factory. Material Safety Data Sheet for the Paso
27/12 is available upon request.

HANDLING CAUTIONS:
1. Keep battery away from Children.
2. Do not short circuit terminals.
3. Do not overcharge. (Caution: Severe overcharging may release sulfur
oxide fumes)
4. Do not place the battery in a container or bag without proper ventilation.
5. Do not place the battery near or in flames. (Caution: Severe overheat-
ing may cause sulfur oxide fumes.)
6. Keep lighted cigarettes, sparks and flames away from charging battery.
7. Operate at a temperature between -15 degrees C to 50° degrees C.
8. To properly store the battery, disconnect terminals and remove from
equipment or charger and store in a cool dry place.
9. Immediately recharge after discharging.
10. Do not crack battery case.
11. Avoid contact with sulfuric acid electrolyte from battery. Flush with
water. Neutralize with solution of baking soda in water. If acid comes in
contact with eyes, rinse eyes with large amounts of water and immediate-
ly consult a physician.
12. It is unlawful to dispose in landfill. Do not incinerate, puncture, disas-
semble or mutilate. Dispose in accordance with local and Federal regula-
tions.

RECHARGEABLE BATTERY INSTALLATION

RECHARGEABLE BATTERY

COMPARTMENT

USE PASO MODEL 27/12

RECHARGEABLE BATTERY

RECHARGEABLE BATTERY

COMPARTMENT

USE PASO MODEL 27/12

RECHARGEABLE BATTERY

Model 27/12

12 Volt- 7 Ah- Sealed Rechargeable

Lead- Calcium Battery

Maintenance-Free

PROFESSIONAL AUDIO & SOUND

®

BLACK WIRE

RED WIRE

MODEL NO. 27/12

BATTERY CABLE
FROM LECTERN

BATTERY

BATTERY

TOP VIEW

Lectern Battery Compartment View

Battery Cable Connection Diagram

THE POWER CORD MUST BE DISCONNECTED FROM
THE AC OUTLET WHEN INSTALLING OR REMOVING
THE BATTERY FROM THE LECTERN.

RECHARGING: The battery will be recharged only
while the Sound Lectern On-Off switch is in the ON
position or while the Lectern is operating.

1) Procure a 12 volt rechargeable battery. (Paso accessory
model 27/12)
2) Locate the battery compartment at the bottom of the
sound lectern.
3) Remove the two screws holding the battery compart-
ment cover.
4) Remove cover and set aside.
5) Locate the battery cable inside the battery compartment.
6) Attach the battery cable wires by connecting the black
wire to negative (-) and connecting the red wire to positive
(+).

Important Note: Battery polarity must be respected or
damage to the battery and recharger may occur.

7) Position battery inside battery compartment.

8) Replace battery cover by using the two screws provided.

BATTERY HANDLING INSTRUCTIONS

BATTERY INSTALLATION

Advertising
This manual is related to the following products: