Permasteel PS-203 - Manual (Page 2)

ASSEMBLY INSTRUCTIONS:
TOOLS REQUIRED:
#2 Phillips screwdriver
Allen wrench
Please read the cooler manual carefully and assemble according to following steps.
1. Please make sure all parts are accounted for before beginning assembly
2. Place main basin (part A) up-side down on clean soft surface. Attach each leg & wheel
assembly (parts B,C &D) onto main basin using 3pcs truss screws for each leg.
3. Turn over entire assembly and press caster brake level to lock casters. Attach left &
right handles (part H) to main basin using 12 pcs truss screws. Tighten with wrench.
4. Attach bottle-cap catcher (J) to main basin by sliding it down over 2 pre-installed bolts.
5. Attach Basket (part K) to main basin by sliding it down over 2 pre-installed bolts.
6. Attach bottle opener (part I) to main basing using 2pcs 5/32” X 1/2” screws. Tighten with
a Phillips screwdriver.
7. Attach 2pcs lid handles (part F) to cooler lid by using 2pcs 5/32 X1/2” screws (part G)
Tighten with a Phillips screwdriver.
8. Clean inside of cooler completely with soft dry towel. Place cooler lid ( part E) on top of
main basin (A). Your cooler is now ready for use.