Permasteel PS-208 - Manual (Page 2)

ASSEMBLY INSTRUCTIONS:
TOOLS REQUIRED:
#2 Phillips screwdriver
Crescent wrench
Please read the cooler manual carefully and assemble according to following steps.
1. Please make sure all parts are accounted for before beginning assembly.
2. The handles (part 4) and bottle opener (part6) are pre-installed on cooler basin.
3. Place main basin up-side down on clean soft surface attach each leg (parts 9)
using M6*12 bolt screw (part 8) and tighten with wrench into main basin, once
the 4 legs are installed, place the supporting rack (parts 10) on legs, then insert
& tighten each wheel (parts 11&12) into the leg.
4. Attach bottle-cap catcher (parts 9) to main basin by sliding it down over 2
pre-installed bolts.
5.
Attach 2pcs lid handles (parts 1) to cooler lid by using 2pcs 5/32x1/2” screws
tighten with a Philips screwdriver.
6.
Clean inside of cooler completely with soft dry towel. Place cooler lid (parts 2) on
top of main basin your cooler is now ready for use.