Directed Electronics ESP 540 User Manual
Page 19
18
©
1999 Directed Electronics, Inc.
To exit Timer Mode:
Timer Mode can be exited by turning the ignition on with the key
any time that the vehicle engine is not running. You can also exit
Timer Mode using the transmitter by following these steps:
1.
Start the engine by pressing
and
on the transmitter
simultaneously.
2.
Press and release
on the transmitter.
3.
Within two seconds, press and release
and
on the
transmitter again.
4.
The vehicle engine will shut down and the parking lights will
flash four times to confirm that Timer Mode has been exited.
If the vehicle has already been remote started, you may skip
Step One.
This feature allows your system's remote start unit to be tem-
porarily disabled to prevent the vehicle from being remote started
accidentally. This feature is useful if the vehicle is being serviced
or stored in an enclosed area. To disable the remote start, move
the supplied shutdown toggle switch to the OFF position. The
switch can be installed in a location of your choice. Check with
your installer for recommended locations.
LOCATION OF SHUTDOWN SWITCH_________________________
Disabling the Remote Start System