Posiflex PG-200/1D - Manual (Page 16)

Utilities
Adding a Test Code I.D. Prefix to All Symbologies
This selection allows you to turn on transmission of a Code I.D.
before the decoded symbology. This action first clears all current
prefixes and then programs a Code I.D. prefix for all symbologies.
This is a temporary setting that will be removed when the unit is
power cycled.
Add Code I.D. Prefix to All Symbologies (Temporary)
Symbology Charts
Note: “m” represents the AIM modifier character. Refer to International
Technical Specification, Symbology Identifiers, for AIM modifier
character details.
Prefix/Suffix entries for specific symbologies override the universal (All
Symbologies, 99) entry.
Refer to the sections of Data Editing and Data Formatting for
information about using Code ID and AIM ID.
Linear Symbologies
AIM Honeywell
Symbology ID
Possible
modifiers
(m)
ID Hex
All Symbologies 99
Codabar ]Fm 0-1 a 61
Code 11 ]H3 h 68
Code 128 ]Cm 0, 1, 2, 4 j 6A
Code 32 Pharmaceutical
(PARAF) ]X0 < 3C
Code 39 (supports Full ASCII
mode) ]Am 0, 1, 3, 4, 5, 7 b 62
16