Datacard Group RL90 - Manual (Page 38)

Status Monitor
32 RP90 Plus E and RL90 User Guide
01039100 Card Jam happens in the printer. Please
open the printer door and remove the
card after turning off the printer power. 1 Switch off the printer power.
2 See
“Turnover jam” on page 53 to remove
the card.
3 Switch on the printer power.
01039200 Card Jam happens in the printer. Please
open the printer door and remove the
card after turning off the printer power. 1 Switch off the printer power.
2 See
“Retransfer section jam” on page 54 to
remove the card.
3 Check that the card stacker is securely attached
to the card stacker receptacle.
4 Switch on the printer power.
01039300 Card Jam happens in the printer. Please
open the printer door and remove the
card after turning off the printer power. 1 Switch off the printer power.
2 See
“Retransfer section jam” on page 54 to
remove the card.
3 Switch on the printer power.
01039400 Card Jam happens in the printer. Please
open the printer door and remove the
card around the card outlet after turning
off the printer power. 1 Switch off the printer power.
2 Open the printer door and remove the card near
the card discharge slot.
3 Switch on the printer power.
0103A000 Retransfer Film is broken. 1 Repair the retransfer film as described in
“Mending broken ink ribbon or retransfer
film” on page 55
.
2 Press RESET and then ENTER to initialize the
printer one ribbon panel.
0103A100 Mark on Retransfer Film could not be
detected. Please set Retransfer Film
correctly. 1 Make sure that the Retransfer Film is loaded
correctly (see “Load retransfer film” on
page 10 ).
2 Close the printer door and press RESET and
then ENTER to initialize the printer.
0103B000 Ink Ribbon is broken. 1 Repair the ink ribbon as described in “Mending
broken ink ribbon or retransfer film” on
page 55
.
2 Press RESET and then ENTER to initialize the
printer.
0103B100 Ink Ribbon cannot be controlled. Please
set Ink Ribbon correctly. 1 Make sure that the Ink Ribbon is loaded
correctly (see “Load ink ribbon” on page 9 ).
2 Close the printer door and press RESET and
then ENTER to initialize the printer.
0103BB00 Card Jam happens in External IC unit.
Please remove the card in External IC
unit. 1 Switch off the printer power.
2 Remove the jammed card from the IC unit on
the right side of the printer.
3 Switch on the printer power.
01044400
0104D800
0104FA00 Hardware failure happens in the printer
unit. Please turn off and on the printer
power to initialize the printer. 1 Turn the printer power switch off and then on.
2 If the error happens again, call for service.