PSE Archery Phantom Arrow Rest - Manual (Page 2)

8.
Tie 3 more serving knots around the cable and rope but do not
cinch tight.
9.
Draw the bow back to full draw. This allows the rope to pull
through the cable to the proper length for initial adjustment.
10.
Pull rope through the cable so that the rope is 1/8” shorter
between the cable and the rest.
11.
Continue the serving over the cable and rope until the serving
is about an inch long.
12.
Lift the rope out of the way and tie three additional serving
knots around the cable only. Separate the individual line of the
serving and tie an overhand knot to finish.
13.
Cut the serving line and the rope leaving about ¼” and burn
the ends being very careful not to damage the string or cable with
the flame.
14.
Draw the bow to see if the launcher lifts to its most upright position. The rest should come to its full upright position no sooner than 2” from
full draw.
15.
After the arrow rest is set up and the center shot is set, mount
the arrow holder on the shelf. Clean the area thoroughly with
alcohol and glue it in place with cyanoacrylate glue.
NOTE: If the arrow holder has double-side tape, remove the
tape and clean thoroughly with alcohol before apply glue.
Precision Shooting Equipment
P.O. Box 5487
Tucson, Arizona 85703
PN 8866 Rev 8/08
Note: A right-hand rest is
shown. Left hand is
opposite.
8
9
10
11 13
1”
12