PSE Archery Compound Bow Set-up Procedures - Manual (Page 5)

17. Install the sight following carefully the instructions provided with the sight. Some bows are equipped with
multiple holes for mounting the sight. Select the set of holes that allows the short-distance pin in the sight to
be toward the top of the sight when viewed through the peep sight with the sight in the middle of it’s vertical
adjustment range. This allows for use of multiple pins.
18. Secure the bow in a bow vise in a level position. Adjust the bow so that it is level. Place a leveling device
on a flat surface of the sight mounting bracket. With the bubble in the leveling devise centered, adjust the
sight so that the bubble in the sight is centered.
19. Adjust the third axis of the sight. Check the third axis leveling by tilting the bow forward. The levels on the
sight and the riser should still be centered. Then tilt the bow to the rear and make the same check.
Holes for mounting sight
Short-distance Pin
Set sight in the middle of
the elevation adjustment
range.