Ready-Set-Mount CC-F50 Francesca - Manual (Page 4)

Secure the pivot bracket (K) to the top of the central upright with M6 x 45mm allen screws (J),
M6 washers (L), and M6 nuts (M).
Affix the U-bracket (O) with M 10 x 25mm (P), M10 washers (Q), and M10 locknuts (R).
Attach the short L-brackets (T) to the U-bracket and then the mount arm supports (V) to the
L-brackets using M6 x 16mm allen screws (U), M6 washers (L), and M6 nuts (M).
Attach the curved frame sections (A and A1) to the ends of the horizontal top tubes (B and C) using the
M6 x 55mm allen screws (G) provided (see Step 1 diagram).
Press the suction cups (F1) into the upward facing holes in the horizontal beams and the shelf supports.
Attach the cable management upright (H) to top tube (B) using M6 x 55mm allen screws (G).
Also, secure this part to the shelf supports (D and E) using M6 x 35mm allen screws (F).
Over-tightening these fasteners will prevent the swivel function from operating smoothly.
Attach the central upright (I) to the cable management upright (J) using M6 x 45 mm allen screws (J).
Fasten the smaller shelf support (D) to the middle of the curved frame sections.
Take the bottom shelf support (E) and attach to the frame using M6 x 35mm allen screws (F).
STEP 4
STEP 3
STEP 2
STEP 1
STEP 5
STEP 6
Attach the mount arm support (V) to the L-brackets using M6 x 16mm allen screws (U),
M6 wahsers (L) and M6 nuts (M).
STEP 7
Place the glass shelves (X, X1, and X2) on the top, middle and lower supports as shown in the diagram.
Do not over-tighten your screws as this may lead to damage of your panel.
Confirm the correct hardware needed to attach the mount arms (U) to your flat panel display
Using the correct hardware, securely fasten the tv mount arms to the back of your panel.
STEP 8
STEP 9