REMKO MXD 200 v.3 - Manual (Page 8)

The indoor unit is easy to operate
using an infrared remote control.
This is supplied as standard.
The indoor unit beeps to
acknowledge the correct
transmission of data.
If it is not possible to program
the indoor unit with the remote
control, then it can also be
manually operated.
Manual operation
The indoor units can be put into
operation manually. After the air
inlet screen has been opened,
the inner recessed button can be
pressed and automatic mode can
be activated.
In manual operation, the following
settings apply:
Cooling mode: last setting
Fan speed AUTO
Heating mode: last setting
Fan: AUTO
Press the button on the infra-red
remote control to interrupt manual
operation.
Infrared remote control
The infrared remote control
sends the programmed settings
in a distance of up to 6 m to the
Display on indoor unit
The display lights up according to
the settings.
receiver of the indoor unit.
A trouble free reception of data is
only possible if the remoter control
is directed to the receiver and no
objects hinder the transmission.
First insert the supplied batteries
(two each, Type AAA) into the
remote control.
To do so, remove the cover on the
battery compartment and insert
the batteries, in correct polarity.
(see marks).
Operation
Problems are shown in code
(see chapter Troubleshooting
and Customer service).
CAUTION
Immediately replace flat
batteries with a new set,
otherwise there is a risk of
leakage. It is recommended
that the batteries are removed
if the equipment is shut down
for long periods.
NOTE
max. 6 m
Maximum distance
Display on indoor unit
Display
Defrosting / heating Compressor speed Automatic mode
Timer
activated/deactivated
Display for setpoint
and gauge
REMKO MXW
8