REMKO RXW 261 - Manual (Page 5)

The equipment is shipped in sturdy
transport packaging. Immediately
check the equipment on delivery
and make a note of any damage or
missing parts on the delivery note.
Inform the forwarding agent and
contractual partner.
Warranty claims at a later date will
not be accepted.
Description of the
equipment
Transport and
packaging
The indoor unit on the split-design
combined room air conditioning
units serves to extract heat from
the indoor room being cooled. The
outdoor component then expels
this heat to the outside.
If combined heating/cooling
units are operated as heaters, the
heat absorbed by the outdoor
component can be discharged
by the indoor unit into the room
being heated.
The unit is designed for installation
high up on indoor walls.
It is operated via an infrared
remote control.
The indoor unit consists of a fin
vaporiser, vaporiser fan, regulation
system and condensation pan.
The indoor unit can be combined
with REMKO outdoor components
that provide sufficient cooling
output. The outdoor component is
controlled via the regulation of the
indoor unit.
Condensation pumps
are available as an accessory.
Schematic of refrigerant circuit
Vaporiser fan
Connection to suction line
Connection to injection line
Vaporiser
Refrigerant pipes are used to connect the indoor unit to the outdoor
component.
Outdoor component
System design
Stop valve
Indoor unit
Liquefier fan
Injection pipe
Suction pipe
Indoor area
Outdoor area
Condensation pipe
Control cable
Mains cable
Condensation pipe
RXW 261 RXW 351 RXW 521 RXW 681
RXS 261H •
RXS 351H
•
RXS 521H •
RXS 681H
•
Combinations
Cooling / heating
RXW 261 RXW 351 RXW 521 RXW 681
RXM 226
••
RXM 235 ••
RXM 252 ••
RXM 268
••
RXM 326
•• •
RXM 335
•••
RXM 426 ••••
RXM 435
••••
Cooling
5