RGBLink VSP 516S User Manual - Manual (Page 125)

VSP 516S User Manual 125
(1) Connect the USB interface of VSP 516S to the computer with a USB cable.
(2) Plug in the power cord, and make sure the device is in normal operation.
(3) Push MENU button, and enter [USB UPDATE] option, operation steps are:
MENUSYSTEMUSB UPDATESEL.
(4) Open the USB drive that plug into the computer, and delete the "firmware. bin" file in
the USB drive, then copy the MCU file "VIDEO.fvb" of VSP516S to the USB,
program loading is complete after the file has been copied.
(5) Reboot the device, and enter the menu to check if the version is right, factory reset is
completed. Operation steps are: MENUSYSTEMSYSTEM INFOVIDEO VER.
Method 2: Upgrade by copy the file, the name of the file is: VIDEO.fvb, and upgrade steps
are as follows:
1. Connect VSP 516S and computer with cable.
2. Start the network function, specific steps are as follows:
MENU--SYSTEM -- ETHERNET -- NERWORK, select ON, and check the IP address of
the equipment, confirm if it is consistent with the computer, such as 192.168.0.***, take
192.168.0.100 for example.
3. Open the webpage, input IP：192.168.0.100 (this is the default state, if the IP address is
changed, the IP address input should be consistent with the changed IP address), then
input the user name: admin, password: rgblink123, click OK.
4. Enter the webpage, click "Fireware Upgrade" and load the page, as shown: