Scotsman F1222L User Manual

Page 10

Advertising
background image

N0922L, N1322L, F1222L, F1522L

D Series Remote Low Side User Manual

October 2014

Page 10

Final Check List

After Connections

1. Wash out the bin. If desired, the interior of the bin

could be sanitized.

2. Locate the ice scoop (if supplied) and have it

available for use when needed.

Final Check List:

1. Is the unit located indoors in a controlled

environment?

2. Is the unit located where it can receive adequate

cooling air?

3. Has the correct electrical power been supplied to

the machine?

4. Have all the water supply connections been

made?

5. Have all the drain connections been made?

6. Has the unit been leveled?

7. Have all unpacking materials and tape been

removed?

8. Is the correct switch bezel installed in the trim

strip?

9. Is the water pressure adequate?

10. Have the drain connections been checked for

leaks?

11. Has the bin interior been wiped clean or sanitized?

12. Have any water filter cartridges been replaced?

13. Have all required kits and adapters been properly

installed?

14. Has the ice machine been properly connected to

the condensing unit or rack?

Control Operation

Use and Operation

Once started, the ice machine will automatically make

ice until the bin or dispenser is full of ice.

When ice level drops, the ice machine will resume

making ice.

Caution: Do not place anything on top of the ice

machine, including the ice scoop. Debris and moisture

from objects on top of the machine can work their way

into the cabinet and cause serious damage. Damage

caused by foreign material is not covered by warranty.

There are four indicator lights at the front of the

machine that provide information on the condition of

the machine.

Indicator Lights:

• Power

• Status

• Water

• De-scale &

Sanitize

Under the door are two switches – On and Off. To

switch the machine OFF, push and release the Off

button. The machine will shut off at the end of the next

cycle.

To switch the machine ON, push and release the

On button. The machine will go through a start up

process and then resume ice making.

Switch Door

Advertising
This manual is related to the following products: