Sea Eagle FastTrack Kayaks (385FT, 385FTG, 465FT) - Manual (Page 15)

Hardware for the swivel
seat comes standard
with the fishing module
and includes 4 bolts, 4
washers and 4 nuts.
Line up the seat mount
on top of the aluminum
filler tubes in the center
of the aluminum seat
board. Once aligned in-
sert the four bolts
through the top of the
seat mount.
Once the bolts are in,
install the washer and
nut on the underside of
the seat board.
Use the screwdriver to
hold the bolt while you
tighten the nylock nut
with the wrench.
The fishing modules
also comes with two
fishing rod holders,
hardware and mounts.
There are pre-drilled
holes at the ends of the
aluminum seat board.
Place the rod holder
mount into the mounting
holes and secure with
screws using a Phillips
head screwdriver.
Align the groove in the
rod holder with the slot
in the base and push
the rod holder into the
base. It can be adjusted
by lifting, turning and
pushing down to lock.
Once the release-a-seat
mount is installed you
can slide the swivel seat
into the module and
place it inside of your
fully inflated Sea Eagle.
The fishing module will
fit snug inside of the
kayak and doesn’t re-
quire any further secur-
ing.
.
OPTIONAL ACCESSORIES (continued)
14