Sea Eagle QuikSail - Manual (Page 3)

Assembly
QuikSail Includes:
Neil Pryde Sail
5' Rope-Stay System
Velcro Strap
Folding Frame
Storage Bag
Begin by unfolding the
frame to full length and
insert the halves for
each pole.
Locate the openings at
the bottom of the sail
and feed a pole from
the wider end of the
frame into each one of
the openings on the
sail. It is best to feed
both poles of the frame
into the sail at the same
time until the frame is
fully inserted.
Rope-Stay System
Use a simple overhand
knot and secure the
rope-stay to one of the
D-Rings located forward
of the seat. For kayaks
that are not equipped
with D-Rings, tie one
end of the rope-stay to
the loop on the base of
a deluxe inflatable seat
as shown.
Assembly
Place the QuikSail in
the bow of your kayak
so that its far enough
forward that you can
brace your feet against
the frame.
Run the rope-stay
around and then
through the middle of
the frame just below the
sail.
Adjust the clip at the
end of the rope-stay
and then secure it to the
D-Ring on the opposite
side located forward of
the seat. For kayaks
that are not equipped
with D-Rings you can
secure the clip to the
loop on the base of a
deluxe inflatable seat.
The rope-stay system
supports the QuikSail
for hands free operation
and assembly is now
complete.
TIP: Brace your feet
against the bottom of
the frame to steady and
support the QuikSail.
2