Seaward DO7e - Manual (Page 19)

Remote Start Socket
Connect remote switch to pins 1 and 2 when switch closed it acts as MEAS key
Digital Microhmmeter Type DO7e Operating Instructions
16
Description
Calibration Standard
Ordering Code
MTS2
Description
Pt100 Temperature Sensor Probe length 200mm, diameter 6mm.
Fitted with 1 Metre Lead and DIN Plug
Ordering Code
5000-Pt100
Description
1 metre wire clamp with hardwood base suitable for cable
diameters up to 100mm
1 metre wire clamp with metal base and provision for temperature
sensor suitable for wire cross section 1 to 1000mm
1 metre wire clamp with water bath for the precise measurement
of 1 meter cable samples 1 to 1000mm
Ordering Code
C02
C02-A
CO3
TEMPERATURE PROBE
WIRE CLAMPS
For the precise measurement of 1 meter cable samples we offer 3 wire clamp options.
Description
Duplex Handspikes with 2.5 metre lead length, current and
potential spikes suitable for plate or Bussbar measurements.
Duplex Handspikes as a HS01-P but with 2.5 and 15 metre lead lengths
Large Kelvin clips with 3 metre lead length suitable for attaching
to rods bars or cables up to 38mm diameter
As LS03-P but with lead lengths 3 and 15 metres
Executive lead set consisting of 4 x 1 metre leads with banana
plugs, 4 x crocodile clips 4 x test prods and 4 x Kelvin clips (KC1)
jaw opening 4mm
Kelvin lead set comprising of miniature Kelvin clips (KC2) with 1
meter leads attached terminated with banana plugs Jaw opening
6mm. Suitable for fi ne wires.
Ordering Code
HS01-P
HS02-P
HS03-P
HS04-P
LS05
LS06-P
20. AVAILABLE ACCESSORIES
MEASURING LEADS
The DO7e may be used with a variety of lead sets. The following are the available selection.
Remember, if you do not see suitable leads for your application, please consult our
customer help desk.
Viewed from panel