Seiko V175 - Manual (Page 15)

29
English
English
28
TO PRESERVE THE QUALITY OF YOUR WATCH
Repair of divers watches requires special expertise and equipment. If you
find that your diver's watch is malfunctioning, do not attempt to repair it but
immediately send it to SEIKO CUSTOMER SERVICE CENTER.
n TEMPERATURES
The key components in mechanical watches are made of metals, which expand or contract
depending on temperatures due to metal properties. This exerts an effect on the accuracy
of the watches. Mechanical watches tend to loss time at high temperatures while they
tend to gain time at low temperatures.
n CHEMICALS n PERIODIC CHECK
2 - 3
Years
n MAGNETISM
Your watch will be
adversely affected by
strong magnetism.
Keep it away from
close contact with
magnetic objects.
N S
It is recommended that the
watch be checked once every 2
to 3 years by an aUTHORIZeD
SeIKO DeaLeR or SeR vICe
CeNTeR to ensure that the
case, crown, gasket and crystal
seal remain intact.
Be careful not to expose the
watch to solvents, mercury,
cosmetic spray, detergents,
adhesives or paints. Other-
wise, the case, bracelet, etc.
may become discolored, dete-
riorated or damaged.
HOW TO USE THE TELEMETER
Before beginning, check that the stopwatch has been reset.
START
(Flash of light)
STOP
(Crash of thunder)
Press Button A to start the
stopwatch as soon as you
see light.
When you hear the sound,
press Button A to stop the
stopwatch.
Read the telemeter scale
that the STOPWATCH 1/5-
second hand points to.
Approx. 3 km
• Please note that the STOPWATCH 1/5-second hand moves in 1/5-second increments and does not
always point exactly to the graduations of the telemeter scale. The telemeter scale can be used
only when the measured time is less than 60 seconds.
3
2
1