Skutch Electronics CK-1A6 - Manual

Page 1 of 4
"Telecommunication Products to solve Telecommunication Problems"
CK-1A6
Promotion-On-Hold Module
For the AT&T phone models:
SB67118, SB67138, SB67158
3/7/14 (3D PAD)
Introduction
Thank you for purchasing the Skutch
CK-1A6 Promotion-On-Hold Module for
the AT&T SB67118, 138, 158 four line
cordless phone systems. This unit
ONLY works with these phone models.
The CK-1A6 is a true plug and play
device. This unit requires an external
sound source such as a MP3 Player or CD
Player to provide the Promotion-On-Hold
audio. When a call is placed ON HOLD
or TRANSFERRED to another phone,
from the base or any cordless phone, the
ON HOLD caller will hear the
Promotion-On-Hold audio. When the line
is re-answered, the audio automatically
stops. It's that simple!
Installation
1- Position the CK-1A6 box under the
base telephone with the jacks facing towards the back of the phone. (See Fig. 3).
2- The SENSOR Board MUST be stuck to the phone or this unit will not function.
3- Make sure that the surface on the telephone is clean and free of dust and/or oil.
4- Peel the paper protectors off back side of the "SENSOR BOARD" and attach it to the
phone as shown in Fig. 2. Note that the SENSOR Board MUST cover the Line buttons
on the phone and must fit flush against the phone. The Sensor Board has been designed to
CK1A6
Power Cube
Sensor Board
Flat Cable
Audio Cable
RCA to RCA
RCA to 1/8” Adapter
CK1A6 installed on SB67118