Skutch Electronics CK-1R2 - Manual

Page 1 of 4
"Telecommunication Products to solve Telecommunication Problems"
CK-1R2
Promotion-On-Hold
Module
(For RCA 25250 & 25210)
3/26/09
Introduction
Thank you for purchasing the Skutch
CK-1R2 Promotion-On-Hold Module.
The CK-1R2 is a true plug and play
device. The unit does not require any
"Learning" to operate. When a call is
placed ON HOLD from any one of the
cordless phones, the caller will hear the
Promotion-On-Hold audio. When the line
is re-answered, the audio automatically
stops. It's that simple!
It should be noted that the 25250/25210
telephones BEEP every 10 seconds when
placed ON HOLD. This is a function of
the telephone, NOT the CK-1R2. This
BEEP can NOT be disabled. The BEEP
will be heard along with the Production-
On-Hold Audio.
Installation
1- Position the CK-1R2 black box under
the base telephone with the jacks facing
towards the back of the phone.
(See Fig #1).
2- Disconnect the modular cord from the back of your phone at the jack labeled [LINE 1
+ 2], and connect it to the black box jack labeled, [1&2 Line].
Sensor Board
CK-1R2
Components
Sensor Cable
Short Mod cord to Phone
Power Cube
Black Box
Audio Cord (CD Player ONLY)