Skutch Electronics CK1 - Manual

Gluing Instructions for CK1 Sensor Board
If you find that your CK-1 sensor board will not stay attached to your telephone, it
will be necessary to glue the Sensor Board to the telephone with Contact Cement. Only
Contact Cement should be used, no other type of glue should be used. Please follow these
instructions carefully.
Needed Materials:
1. A small jar of Contact Cement. This is available at most hardware stores
including Home Depot and Lowes.
2. At least one Q-Tip swab.
3. A piece of paper
4. Either a bottle of rubbing alcohol and a small cloth towel, or a alcohol prep pad.
Instructions:
1. Completely remove the CK1 Sensor Board from the telephone.
2. With a small amount of rubbing alcohol, or with a rubbing alcohol prep pad, clean
the surface of the phone where the CK1 Sensor Board will mount. There must be
no dust or oil film, on the phone where the Sensor Board will mount. DO NOT
allow excess alcohol to drip inside phone. This could damage your phone.
3. Wait until the phone surfaces are completely dry before continuing.
NOTE: The following are time sensitive steps. Once you start you must keep going
until you have completed all of the instruction. Please completely read through the
following steps before you attempt them, so that you will be familiar with them.
4. Brush a small amount of Contact Cement on the piece of paper as shown in
Picture 1.
5. Dip the Q-TIP into the glue, on the paper, and apply a medium coat of Contact
Cement to the bottom of the sensor board as shown in Picture 2. DO NOT get
any Contact Cement on the Photo Cells on the bottom of the sensor board.
DO NOT apply so much glue that it will run off the pad when the sensor board is
turned over.
6. Now temporarily mate the sensor board to the telephone, where it is to be
permanently attached. Press down so that the glue from the sensor board pad
ELECTRONICS, INC.
209 Kenroy Lane #9
Roseville, California 95678
Voice (916) 786-6186 FAX (916) 783-1909
[email protected] : www.skutchelectronics.com E-MAIL: WEB