Skutch Electronics CK-1A4 - Manual

Page 1 of 4
"Telecommunication Products to solve Telecommunication Problems"
CK-1A4
Promotion-On-Hold
Module
For the AT&T 1040, 1070, and 1080
series of Phones
V3 2/4/09
Introduction
Thank you for purchasing the
Skutch CK-1A4 Promotion-On-
Hold Module for the AT&T
1040, 1070, and 1080 four line
phone system. This unit ONLY
works with these 3 phone models.
The CK-1A4 is a true plug and
play device. The unit does not
require any "Learning" to operate.
When a call is placed ON HOLD
from any of the phones, the ON
HOLD caller will hear the
Promotion-On-Hold audio. When the line is re-answered, the audio automatically stops.
It's that simple!
Installation
The SENSOR Board MUST be stuck to the phone or this unit will not function.
1- Make sure that the surface on the telephone is clean and free of dust and/or oil.
2- Peel the paper protector off back side of the "SENSOR BOARD" . Carefully align as
shown in Fig. 2. Note that the top and left, edges of the SENSOR Board align with the
bottom and left, edges of the display on the phone. Also note that the "white dashes" on
the SENSOR board should be vertically centered over the LINE 1-4 LEDS on the phone.
Once you are SURE it is aligned correctly, press down firmly to adhere to phone.
Sensor Board
Power Cube
Audio Cable (For CD Players ONLY)
CK-1 Box
CK-1A4 Installed on 1040