Skutch Electronics CK-1A4 Rev.2 - Manual

Page 1 of 4
"Telecommunication Products to solve Telecommunication Problems"
Revision 2 Sensor Board
CK-1A4
Promotion-On-Hold
Module
For the AT&T 1040, 1070, and 1080
series of Phones
REV 2 V1-S/N A9060001 and above-
5/21/09
Introduction
Thank you for purchasing the
Skutch CK-1A4 Promotion-On-
Hold Module for the AT&T
1040, 1070, and 1080 four line
phone system. This unit ONLY
works with these 3 phone models.
The CK-1A4 is a true plug and
play device. This unit requires an
external sound source such as a
CD or Digital Player to provide
the Promotion-On-Hold audio. When a call is placed ON HOLD from any of the phones,
the ON HOLD caller will hear the Promotion-On-Hold audio. When the line is re-
answered, the audio automatically stops. It's that simple!
Installation
The SENSOR Board MUST be stuck to the phone or this unit will not function.
1- Make sure that the surface on the telephone is clean and free of dust and/or oil.
2- Peel the paper protector off back side of the "SENSOR BOARD" . Carefully align as
shown in Fig. 2. Note that the SENSOR Board aligns with the black edge of the display
window on the phone. The Sensor Board should completely cover the Line lights on the
phone. Once you are SURE it is aligned correctly, press down firmly to adhere to phone.
CAUTION: The SENSOR BOARD must be aligned correctly or the unit will not
operate properly. If you need to remove the SENSOR BOARD once it is attached,
Power Cube
Sensor Board
Audio Cord
(For CD Players ONLY)
CK-1A4