Skutt GP706 - Manual (Page 3)

3
KILN SWITCH OPERATION
The power control switch of your kiln is similar to the switches found on most ranges. The higher the
switch setting, the hotter the kiln will get. On LOW setting, power is supplied to the kiln about 20% of
the time. On setting #4 the power is on about 50%, setting #6 about 80% and on HIGH 100%. Some
experimentation will be necessary to determine what settings are best for your application.
This particular type of switch is called an “infi nite” switch. It is (infi nitely) adjustable between LOW
and HIGH settings. On settings other than HIGH, the kiln’s pilot light will cycle on and off as the infi -
nite switch cycles on and off.
MAINTENANCE AND CARE OF YOUR KILN
Always close the lid of your kiln gently. Since the heating elements are in the kiln lid, any sudden jar,
such as the lid slamming shut, can dislodge the heating elements or the pins that hold the elements in
place. If the lid is slammed forcefully enough, the brick in the kiln lid may fracture and break loose.
This type of damage is generally not covered by your kiln’s warranty.
After each fi ring, the lid and heating elements should be inspected. Any pins holding the heating ele-
ments in place that appear to be coming loose should gently be pushed back into place.
Kiln wash should be used on the kiln’s interior surface if there is danger of glazes or glass melting onto
these surfaces. The heating elements should NEVER be coated with kiln wash.
PILOT LITE
L2
L1
G
Switch
Infinite
Pinto
Lid
Plug
15 Amp
110 Volt
L2
L1
P H1
H2
Model: Pinto
Voltage: 110
Phase: 1
Amps 14.7
W_092
W
IRING
D
IAGRAM
O
PERATING
I
NSTRUCTIONS