Skutt Oval Kiln - Manual

6441 SE Johnson Creek Blvd., Portland, OR 97206 Phone (503) 774-6000 Fax (503) 774-7833 www.skutt.com
TAB TEXT HERE
TAB TEXT HERE
TAB TEXT HERE
TAB TEXT HERE
KM OPERATING MANUAL
0.2.2 REV 8/30/00 0.2.2 REV 8/30/00 0.2.2 REV 8/30/00 0.2.2 REV 8/30/00 0.2.2 REV 8/30/00
ADDENDUM
(continued)
Oval Kiln Addendum
SETUP AND
SPECIFICATIONS FOR THE SKUTT OVAL KILN
Unpacking
The Oval kiln will be packed in 2 separate boxes which will include the following:
Box 1
a. Oval Kiln
b. 3 Piece Fiber Slab Insert
Box 2
a. 2 Piece Kiln Stand with slab supports
b. 6 Peep Plugs
c. “Goodie Bag”
Operating Manual
Zone Control Addendum
Warranty Card
12 Plastic Stand Feet
Lid Prop
d. 14 2” Posts
Set Up
Follow the instructions on kiln setup in the “Automatic Kiln Set Up” section of the KilnMaster
Automatic Kiln manual which was included with your kiln purchase. There are 4 main differ-
ences that should be noted when setting up the Oval kiln.
1 Due to the weight of the Oval kiln, you will want to separate the kiln into
sections when you set it up. Please consult the instructions “Disassembling a
KM1627PK Oval Kiln”
2 The kiln has 2 stands that fit together which include a 2 piece stainless steel slab
support system. Place the stands flush together and center the supports on top
of the stands. If you have purchased the Envirovent Downdraft Ventilation
System the vents will be attached to the slab supports and they will be packaged
separately.
3 The Oval kiln includes a 3 piece rigid fiber insert that fits inside the bottom
section on top of the slab. There are holes cast in the insert which hold the 2 inch
ceramic posts. Carefully lay the fiber insert on top of the slab after the first
section is placed in position and insert the posts.
4 The Oval kiln comes standard with a Zone Control KilnMaster Controller.
Please see the Zone Control Addendum for programming instructions.