SL Power Electronics GLC75 Multiple Output User Manual
SL Power Electronics Equipment
SL POWER ELECTRONICS CORP.
6050 King Drive, Bldg. A
Ventura, CA 93003 + 805-486-4565
Internet: www.slpower.com
MODEL NUMBERS: GLC75X where X may be the letter A, B, C, D, E, F, H, J or P. Models may be followed by -CV,
-L, -LC, -V, -XXX and/or G. Suffix –CV indicates optional voltage adjust for output #1 and bracket/cover; -L indicates
optional L bracket; -LC indicates bracket/cover; -V indicates output adjust for output #1; -XXX indicates value added
configurations that have no impact on safety which may be any number from 001 thru 999; and/or G indicates compliance to
RoHS.
RATINGS:
Input: 100-240 V ac, 3.1 A, 50/60 Hz
Output: Maximum Continuous Power,
total of all outputs at ambient of 50 °C.
Output #1
Output #2
Output #3
Output #4
MODEL
Note 1
Note 2
Note 1
Note 2
Note 1
Note 2
Note 1
Note 2
GLC75A
+5.1 V
8 A
10 A
+12 V
2.5 A
3.0 A
-12 V
1.0 A
1.0 A
+12 V
2.5 A
3.0 A
GLC75B
+5.1 V
8 A
10 A
+12 V
2.5 A
3.0 A
-5 V
1.0 A
1.0 A
+12 V
2.5 A
3.0 A
GLC75C
+5.1 V
8 A
10 A
+12 V
2.5 A
3.0 A
-15 V
1.0 A
1.0 A
+15 V
2.5 A
3.0 A
GLC75D
+5.1 V
8 A
10 A
+24 V
2.5 A
2.5 A
-12 V
1.0 A
1.0 A
+12 V
2.5 A
3.0 A
GLC75E
+5.1 V
8 A
10 A
+24 V
2.5 A
2.5 A
-15 V
1.0 A
1.0 A
+15 V
2.5 A
3.0 A
GLC75F
+5.1 V
8 A
10 A
+15 V
2.5 A
3.0 A
-5 V
1.0 A
1.0 A
-15 V
2.5 A
3.0 A
GLC75H
+5.1 V
8 A
10 A
+15 V
2.5 A
3.0 A
-15 V
1.0 A
1.0 A
+15 V
2.5 A
3.0 A
GLC75J
+5.1 V
8 A
10 A
+12 V
2.5 A
3.0 A
-12 V
1.0 A
1.0 A
5 V
2.0 A
3.0 A
GLC75P
+5.1 V
8 A
10 A
+24 V
4.0 A
4.0 A
-12 V
1.0 A
1.0 A
+12 V
2.5 A
3.0 A
Notes:
1. Maximum ratings for 0 CFM airflow without chassis/cover.
2. Maximum ratings for 26 CFM airflow.
3. Contact SL Power Electronics Corp Technical Support for airflow requirements when using chassis/cover option.
4. Maximum Operating Relative Humidity 96 %, no condensation.
5. Storage: -40 to +85 °C. Units should be allowed to warm-up under non-condensing conditions before application of power.
SAFETY DECLARATION: SL Power Electronics Corp. declares under our sole responsibility that all
models listed above are in conformity with the applicable requirements of EN 60950-1 following the provisions
of the Low Voltage Directive 73/23/EEC. All models are Certified to be in compliance with the applicable
requirements of UL 1950, CSA 22.2 No. 950-95 (Level 3), and EN 60950-1 for Pollution Degree 2 environment
and Class I TN-S power systems. The outputs of the supplies meet the requirements for SELV and are not an energy hazard.
GROUNDING: The Earth (ground) terminal J1, pin 1, must be bonded to Protective Earth in the end application to preserve
the intended safety. Using the Earth terminal on the supply for grounding the end product’s protective earthing terminal is
not recommended. A separate dedicated protective earthing point should be used.
SPACINGS: The required creepage and clearance distances from primary circuits to ground and secondary circuits must be
maintained after installation to preserve the intended safety.
TEMPERATURES: The maximum operating temperatures of certain safety components, as defined in the applicable safety
standards, must not be exceeded after installation to preserve the intended safety. The output power, ambient air temperature
and the availability, amount, direction and/or restriction of airflow influence the temperatures of these components.
WARNING! RISK OF FIRE! A blown internal fuse is an indication of catastrophic failure of circuit component(s).
Repair must be performed by SL Power Electronics Corp. authorized personnel. Refer to fuse marking on the supply for type
and rating.
WARNING! SHOCK HAZARD! Dangerous voltages are present on some components, printed wiring traces and
heatsinks.
C O N N E C T I O N S
J1 Pin
AC Input
J2 Pin
DC Output
J2 Pin
DC Output
MATING CONNECTORS
1
Ground
1,2,3
Output #1 +
11
Output #3 -
J1 - Amp Housing 640250-5
3
Neutral
4,5,6,7
Common
12
Output #4 -
Pin 770522-1
5
Line
8,9
Output #2 +
13
Output #4 +
J2 - Amp Housing 1-640250-3
10
Power Fail
Pin 770522-1
CAUTION: Do not exceed 5 A per contact.
SL Power Electronics Corp. will not be liable for the safety, reliability or performance of these power supplies if a) any changes, modifications or repairs are carried out by other than authorized agents of SL
Power Electronics Corp., or b) the installation of the supply is not in accordance with these installation instructions and the applicable UL, CSA, EN/IEC safety standards.
41-34203-0001 Rev. K 09/14/06
GLC75 MULTI-OUTPUT SERIES
INSTALLATION INSTRUCTIONS
Standard
With Chassis/Cover (Note 3)
26 CFM
0 CFM
26 CFM
0 CFM
110 Watts
75 Watts
110 Watts
65 Watts