SL Power Electronics GSM28 - Manual

CONDOR DC POWER SUPPLIES INC.
2311 STATHAM PKWY
OXNARD, CA 93033 + 805-486-4565
RATINGS
Input: 100-240 VAC, 0.9 A, 50/60 Hz.
Output:
Model Volts Amps
Note 1 Note 2
GSM28-5 + 5.1V 5.0A 4.0A
GSM28-12 +12.0V 2.3A 2.0A
GSM28-15 +15.0V 1.9A 1.6A
GSM28-24 +24.0V 1.2A 1.0A
GSM28-28 +28.0V 1.0A 0.86A
Notes: 1. Maximum output current at 50°C ambient.
2. Maximum output current with chassis/cover option at 50°C ambient.
3. Maximum Relative Humidity 96%, no condensation
SAFETY COMPLIANCE STANDARDS: All models are Certified to be in compliance with the
applicable requirements of UL 2601-1 First Edition, CSA 22.2 No. 601.1, and IEC601-1 1988 Amend.
2.
CLASSIFICATION: (5.1) Protection against electric shock = Class I
(In accordance with sub- (5.2) Degree of protection against electric shock = Signal output or intermediate
clause 5 of IEC 601-1) (5.3) Protection against harmful ingress of water = Ordinary (no protection)
(5.5) Have not been evaluated for use in the presence of a flammable anaesthetic
mixture with air, oxygen, or nitrous oxide. This evaluation is made on the end
equipment by the OEM.
(5.6) Mode of operation = Continuous
SAFETY DECLARATION: Condor DC Power Supplies, Inc. declares under our sole
responsibility that all models listed above are in conformity with the applicable requirements
of EN60950 following the provisions of the Low Voltage Directive 73/23/EEC.
    WARNING! RISK OF FIRE! SHOCK HAZARD!            
Dangerous voltages are present on some components, printed wiring traces and heatsinks.
GROUNDING: To maintain proper isolation between mains and output, the ground terminal, J1 Pin1,
must be bonded to Protective Earth in the end application. However, using this terminal for the primary
system earthing terminal is not recommended. Alternatively, #4 screws (max 0.22 inch head diameter)
and metal spacers (3/16 inch diameter, 1/4 inch minimum length) may be used to mount the power
supply to grounded metal surfaces (Protective Earth).
A blown fuse is an indication of catastrophic failure of circuit component(s). Repair must be performed
by Condor authorized personnel.
41-34368-0001 Rev. B 3/9/99
Page 1 of 2
GSM28 SERIES
INSTALLATION INSTRUCTIONS