Sloan 110 Regal Exposed Flushometer - Manual

Code No. 0816312
Rev. 2 (04/14)
INSTALLATION INSTRUCTIONS FOR EXPOSED REGAL ® XL
WATER CLOSET AND URINAL FLUSHOMETERS
LIMITED WARRANTY
Unless otherwise noted, Sloan Valve Company warrants this product, manufactured and sold for commercial or industrial uses, to be free from defects in material
and workmanship for a period of three (3) years (one (1) year for special finishes, SF faucets, PWT electronics and 30 days for PWT software) from date of first
purchase. During this period, Sloan Valve Company will, at its option, repair, replace, or refund the purchase price of any product which fails to conform with this
warranty under normal use and service. This shall be the sole and exclusive remedy under this warranty. Products must be returned to Sloan Valve Company, at
customer’s cost. No claims will be allowed for labor, transportation or other costs. This warranty extends only to persons or organizations who purchase Sloan Valve
Company’s products directly from Sloan Valve Company for purpose of resale. This warranty does not cover the life of the batteries.
THERE ARE NO WARRANTIES WHICH EXTEND BEYOND THE DESCRIPTION ON THE FACE HEREOF. IN NO EVENT IS SLOAN VALVE COMPANY
RESPONSIBLE FOR ANY CONSEQUENTIAL DAMAGES OF ANY MEASURE WHATSOEVER.
Before you install the Regal XL flushometer, be sure the items listed below
are installed. Also, refer to the rough-in diagrams on the next page.
• Closet or urinal fixture
• Drain line
• Water supply line
IMPORTANT:
• INSTALL ALL PLUMBING IN ACCORDANCE WITH
APPLICABLE CODES AND REGULATIONS.
• WATER SUPPLY LINES MUST BE SIZED TO PROVIDE
AN ADEQUATE VOLUME OF WATER FOR EACH
FIXTURE.
• FLUSH ALL WATER LINES PRIOR TO MAKING
CONNECTIONS.
Sloan’s flushometers are designed to operate with 10 to 100 psi (69 to 689
kPa) of water pressure.
THE MINIMUM PRESSURE REQUIRED
TO THE VALVE IS DETERMINED BY THE TYPE OF
FIXTURE SELECTED. Consult fixture manufacturer for minimum
pressure requirements. Most Low Consumption water closets (1.6 gpf/6.0
Lpf) require a minimum flowing pressure of 25 psi (172 kPa).
Closet Flushometer
1½” (38 mm) Top Spud
MODELS 110/111,
113, 115 & 116
Closet Flushometer
1½” (38 mm) Back Spud
MODEL 120 & 122
Service Sink Flushometer
1½” (38 mm) Top Spud
MODEL 117
Urinal Flushometer
1¼” (32 mm) Top Spud
MODEL 180
Urinal Flushometer
¾” (19 mm) Top Spud
MODEL 186
Squat Toilet Flushometer
1½” (38 mm) Back Spud
MODEL 137
PRIOR TO INSTALLATION
TOOLS REQUIRED FOR INSTALLATION
• Straight blade screwdriver
• Sloan A-50 Super-Wrench™, Sloan A-109 Plier Wrench or smooth jawed spud wrench