Sloan MCR 4004-A CONTROLLER - Manual

A SLOAN VALVE COMPANY
LIMITED WARRANTY
Programmed Water Technologies, a Sloan Valve Company,
warrants its products to be made of first-class materials, free
from defects of material or workmanship under normal use
and to perform the service for which they are intended in a
thoroughly reliable and efficient manner when properly installed
and serviced, for a period of one year from date of purchase for
MICROPlumb
® products. During this period, PWT will, at its
option, repair or replace any part or parts which prove to be
thus defective if returned to PWT, at customer’s cost, and this
shall be the sole remedy available under this warranty. No
claims will be allowed for labor, transportation or other
incidental costs. This warranty extends only to persons or
organizations who purchase PWT’s products directly from
PWT for purpose of resale.
THERE ARE NO WARRANTIES WHICH EXTEND BEYOND
THE DESCRIPTION ON THE FACE HEREOF. IN NO EVENT IS
PROGRAMMED WATER TECHNOLOGIES RESPONSIBLE
FOR ANY CONSEQUENTIAL DAMAGES OF ANY MEASURE
WHATSOEVER.
Installation of the PWT MICROPlumb ® MCR 4004, MCR 8002
and MCR 8003 Series Controllers incorporates the latest
advances in microprocessor technology to provide maximum
control of your plumbing system. MICROPlumb’s patented
sensing and metering products can be programmed to do just
about anything you require, when you require it, including the
ability to Delay and Lock-Out fixture activation.
MICROPlumb products control showers, water closets,
lavatories and combination fixtures and help maintain operation
of ON/OFF/DELAY.
These modular, flexible systems for new constructions,
retrofit or expansion applications have few moving parts, no
mechanical metering devices, and operate on low voltage to
ensure safety and reliability.
The following instructions will serve as a guide when installing
the MCR 4000 and MCR 8000 Series Controllers. As always,
good safety practices and care are recommended when
installing your new controller.
PRIOR TO INSTALLATION
Install the items listed below:
• 24 VAC step-down transformer
• Push buttons
• Flushometer
• Lavatory/Shower solenoids
IMPORTANT: All electrical wiring is to be installed in accordance
with national/local codes and regulations.
MCR 4004-A, MCR 8002-AX AND MCR 8003-AX CONTROLLERS
INSTALLATION AND PROGRAMMING INSTRUCTIONS
Made in the U.S.A.