Delphi SA10221 User Manual
Page 24
Setting Up the Antenna
20
Indoor Installation on a Flat Surface
To aim your antenna at the satellite:
1. Set antenna flat against its base on a flat (horizontal) surface.
2. Turn the base of the antenna so that the XM logo is facing to the south.
3. Use the “Antenna Aiming” screen to optimize antenna tilt angle and
position.
4. If necessary, experiment with different locations near a south-facing
window or outdoors.
Your antenna comes with 20’ of cable. If that is not sufficient to locate the
antenna where there is a strong XM signal, purchase the Delphi XM Signal
Repeater (Delphi model number SA10116) from your retailer or
www.shopdelphi.com. Visit www.shopdelphi.com for more information
about this accessory.
There is also a 50’ extension cable for the antenna (SA10006) that
is sold separately.
Outdoor Installation or Indoor Wall Mounting
The antenna can also be attached vertically to an external or internal wall if
that is more convenient than placing it on a horizontal surface.
1. Holding your antenna up, find a wall location that ensures a strong
signal. It is recommended that you use an extension cord to temporarily
locate your receiver’s home stand outdoors while optimizing the antenna
location with the “Antenna Aiming” screen.