Smithco Super Rake 13-55х (sn 6450 – 6594/1200-1301) Parts & Service Manual - Manual (Page 67)

65
Accessories
13-678 CASTOR WHEEL KIT PARTS LIST
REF# PART# DESCRIPTION QUANTITY
1 HB-38-16-150 Bolt 3 /
8
-16 x 1
1 /
2
4
HW-38 Washer 3 /
8
4
HNTL-38-16 Lock Nut 3 /
8
-16 4
2 13-114 Digger Blade (part of 13-107)
3 42-204 Castor Fork 2
4 42-212 Castor Wheel Spacer 4
5 HB-12-13-600 Bolt 1 /
2
-13 x 6 2
HNTL-12-13 Lock Nut 1 /
2
- 13 2
6 42-213 Axle Bearing 2
7 HMB-34-10 Machine Bushing 3 /
4
x 10 GA 8
8 HMB-34-14 Machine Bushing 3 /
4
x 14 GA 2
9 42-539 Lunch Pin 5 /
16
2
10 42-214 Long Spacer 2
11 42-215 Short Spacer 2
12 13-675 Castor Wheel Bracket 2
18-221 Flange Bushing (part of 13-675 ) 4
HG-14-28-180 Grease Fitting ( part of 13-675 ) 2
13 42-202 Tire & Wheel 2
14 13-113 Frame ( part of 13-107)
13-578 Frame ( part of 13-577)
15 26-042 Tine Segment ( part of 13-577)
INSTALLATION INSTRUCTIONS
1. Remove the two outside bolts from each end and replace with 3 /
8
-16 x 1 1 /
2
bolts (Ref 1) with the castor
wheel bracket (Ref 12) on top of the frame (Ref 14) and a washer 3 /
8
and lock nut 3 /
8
-16 tighten.
2. Place a 3 /
4
x 10 GA machine bushing (Ref 7) onto the caster fork shaft (Ref 3) first. Adjust castor wheels
by placing the short (Ref 11) or long (Ref 10) spacers on the castor wheel fork before placing the castor
wheel assembly into the castor wheel brackets. Slide the shaft up through the castor wheel bracket
sleeve. Place spacer(s) not used on the bottom, on the top then add three
3 /
4
x 10 GA machine bushings
and one 3 /
4
x 14 GA machine bushing (Ref 8) onto the castor fork shaft. Hold in place with a lynch pin
(Ref 9). You may use any combination of spacers and machine bushings, as long as you start and end
with a machine bushing. Be sure both castor wheels are adjusted to the same height.
3. Grease the fittings on the castor wheel bracket sleeves.
4. Turn the machine on and test for proper operation.