Smithco Super Star 42-00x (sn 4602 – 4660/12588 – 12627) Parts & Service Manual - Manual (Page 11)

9
Service
ADJUSTMENTS
RAKE LIFT CYLINDER
Completely lower Rake Lift. Remove cotter pin (A) and clevis pin (B).
Place attachment lift arms (C) at
1 /
16
" above cross member (D) on
Rake Lift. Loosen jam nut (E). Twist cylinder extension (F) so clevis
pin end of cylinder extension lines up with holes in attachment lift arm.
Replace clevis and cotter pins. Tighten jam nut. Raise and lower Rake
Lift to check for proper clearance.
When the rear rake attachment is lowered while the
machine is in forward motion, the forward speed of
the machine will slow drastically. Operator should be
prepared for a rapid change in speed.
STEERING CHAIN ADJUSTMENT
Steering Sprockets (A) should be level with each other.
Check with straight edge. Make any adjustments. Adjust the
chain tensioner bolt (B) so that the chain is snug. Tighten all
nuts and bolts in place.
SPEED BOSS
Speed Boss allows the machine to operate at
a proper speed while raking sand traps on golf
courses. This speed boss has been factory set
at an average speed of 3-4 m.p.h. (5-6.5 kph).
The Speed Boss will only limit the speed while
the rake is lowered into the operating position.
The speed setting may be adjusted by turning
the Ball Joint (A) counterclockwise to make
the machine operate slower or turn clockwise
to go faster. Tighten jam nut. Check to make
sure nothing is binding and test drive to check
desired speed.
For RBS System, Spiker and Grader Box re-
move the speed boss arm and the speed boss
rod from machine so it does not interfer with
other operations.