Smithco Tournament Roller 7530 Operator Manual - Manual (Page 3)

SMITHCO TOURNAMENT ROLLERS
The SMITHCO TOURNAMENT ROLLERS are a field developed tool designed to condition the
surface of putting greens, lawn bowling greens, and grass tennis courts to a precise texture for
tournament grade quality.
The Roller utilizes two 8
” rollers to achieve a “billiard table” surface. Both 8” rollers are driven
and both are used for steering.
The TOURNAMENT ROLLER is built of the finest and heaviest material utilized on each part to
insure longevity. The frame is fabricated out of seven gauge steel to provide weight to the
machine and prevent warping. The steering has been especially engineered for operator
comfort to alleviate fatigue during prolonged use. The specially designed, articulated steering
rollers allow the rollers to follow the contour of the green to insure an even compaction over the
entire surface.
Before placing the Roller into service it must be serviced with fuel and the hydraulic fluid
checked. Refer to the manuals furnished for the engine and transmission which will specify fuel
and oils required.
Operator familiarization should be conducted before use of the Roller on the greens. Improper
handling of the roller could cause damage to the turf. Do not allow the roller to stand idle on the
putting surface for any length of time as the weight of the machine will cause indentions that will
be difficult to smooth out. Place the roller into motion while off the green, and never attempt to
turn the steering rollers sharply while the machine is on the green. Do not attempt to turn the
steering wheel while the machine is not in motion.
Each Golf Course Superintendent should plan a pattern for the rolling of his greens so all
greens would be compatible in speed and direction. Most Superintendents will probably decide
that the best method of rolling would be back and fourth in an alternate direction. When
possible, the roller should be run up and down major undulations, not across. Each
Superintendent can decide as to which method is best for his greens.
The Roller should be lubricated frequently with any grade of machine oil at all moving
joints, and the bearings that are furnished with grease fittings should be greased with
any good grade Lithium or equivalent water repellent grease. The Hydraulic pump uses
10W30 or 10W40 nondetergent oil.
THE SMITHCO TOURNAMENT ROLLERS ARE TO BE USED ON GOLF COURSE GREENS,
LAWN BOWLING AREAS AND GRASS TENNIS COURTS ONLY. IT IS NOT TO BE USED ON
ASPHALT, CEMENT, OR GRAVEL AREAS.
Good maintenance and regular servicing will insure the longevity of your SMITHCO
TOURNAMENT ROLLER. Support is readily available from your local distributor or
SMITHCO.
1