Smithco Spray Star 1600P (sn 0979 – 0991) Parts & Service Manual - Manual (Page 117)

115
Accessories
1600P FOAMER TANK MOUNT PARTS LIST
REF# PART# DESCRIPTION QUANTITY
1 16-938 Tank Mount Base 1
2 21-464 4 Gallon Poly Tank 1
26-054 Bushing (part of tank) 1
26-055 Shut Off Valve (part of tank) 1
3 16-939 Foam Tank Strap 1
4 HB-516-18-150 Bolt 5 /
16
- 18 x 1 1 /
2
2
HNTL-516-18 Lock Nut 5 /
16
- 18 2
6 HB-38-16-125 Bolt 3 /
8
- 16 x 1 1 /
4
(part of machine) 2
7 Main Frame
INSTALLATION INSTRUCTIONS
1. For Spray Star 1600: Remove the two outside bolts (Ref 6) from the gas tank bracket angles.
2. Lift the leg from the gas tank bracket (Ref 6) and slide the arm of the tank mount base (Ref 1) between
the leg of the gas tank bracket and the angle iron on the frame (Ref 7). Be sure the plate end of the
foamer tank bracket is pointing to the rear of the machine and parallel with the ground.
3. Using the same bolts and lock nuts (Ref 6), re-bolt tank and foamer tank bracket to angle iron.
4. Place foamer tank (Ref 2) over plate on tank mount base (Ref 1).
5. With tank strap (Ref 3) over tank, use 5 /
16
- 18 x 1 1 /
2
bolt (Ref 4) in back and lock nut on bottom of plate,
just start the nut.
6. Put 5 /
16
- 18 x 1 1 /
2
bolt (Ref 4) in front with lock nut on the bottom of plate, just start the nut.
7. Now completely tighten back bolt then tighten front bolt.