Smithco Spray Star 1710 Operator Manual - Manual (Page 11)

9
Introduction
CONTROLS & INSTRUMENTS
Q. Spray Boss Control - Engages and disengages speed boss. Forward is
engage and all the way back is disengage. When the lever is engaged it
sets a stop for the accelerator. The accelerator pedal must be used to
maintain this speed. To adjust speed use the knob on the end of the lever,
counter clockwise increases speed and clockwise decreases speed.
Disengage the lever and you will have full accelerator pedal range.
R. Cup Holder - Holds standard cup.
S. Ground Speed (Cruise) Control Foot Switch - When rocker switch is truned
on and desired speed is obtained, push foot speed control switch to set
cruise.
T. Reverse / Accelerator Pedal - This pedal controls ground speed. Press
pedal to increase speed. Varying the amount of movement of the pedal will
vary the ground speed. To activate Reverse, you lift up on the pedal with
you toe.
When pedals are released the hydrostatic transmission centers and stops
the vehicle with a braking action.
GROUND SPEED CONTROL
The ground speed control does not work the same as an automotive type cruise. The ground speed control is
located on the center floorboard and is used to lock forward speed.
TO ENGAGE:
1. Flip rocker switch ‘On’ (green light).
2. Obtain desired speed with foot
pedal.
3. Step on foot switch to lock speed.
4. Push foot switch again to disengage.
To avoid abrupt stop, place
foot on traction pedal before
disengaging speed control.