SONOSAX SX-S - Manual (Page 10)

560.8.2 Master assign Switches:
561. The switches L & R direct the signals from the L & R Master Faders to Output A through D.
562. Caution should be exercised if a L or R mixed Output is combined with the output of an individual channel.
563. A Mono mix can be obtained on a single channel by selecting the same output for both L & R.
564.
565.8.3 Overload indicators
566. Overload indicators light whenever a channel is being overdriven.
567.
568.8.4 Monitor Switches
569. The IN/OUT A to D Switches direct the Output of the mixer or the Input to the mixer to the monitoring circuit. These switches are provided with a center Off position.
570. PFL light on the Master module indicates if one or more of these switches is active.
571.
572.8.5 Trim pots
573. The four Trim pots on the circuit board will control the return level.
574. The module is supplied with a ribbon cable with connectors to attach to J-5 of each of the Input modules.
575.
576. RETURN TO TABLE OF CONTENTS
577.
578.
579. 9. ADDITIONAL AUX MODULE
580.
581. The Aux Module provides 2 additional Auxiliary Outputs available on two Bantam Jacks on the rear of the mixer.
582.
583.9.1 AUX Send potentiometers
584. The signal of each of the Inputs can be directed to the 2 Auxiliary Outputs through the potentiometer pairs marked 1 through 8.
585.
586.9.2 External Input
587. If fitted the signal from one external source can be applied to the auxiliary Outputs through the potentiometer pair marked ext.
588.
589.9.3 Aux Master control
590. The potentiometers marked Masters control the final level of the mixed signals to each of the Auxiliary Outputs.
591.
592.9.4 Talkback Microphone
593. If fitted, a 3-pin XLR on the rear panel of the mixer can direct the signal from a microphone through either or both of the pushbuttons to their respective Aux Output. This
provides a simple means of slating to an Aux bus. A limiter circuit prevents overload from the Tbk mic.
594.
595.9.5 Installation
596. Attach the necessary XLR and Bantam Jacks to the mixer's rear panel and fit the module into its slot. The module requires 2 connections to the mix bus ribbon cable.
(An additional 26-pin connector must be installed on the mix bus ribbon cable).
597. A ribbon connector is provided with connectors to attach to J-5 of each Input module. The signal is taken before the Fader of the Input modules.
598. Click here for Drawing of AUX Module Connections
• J-3 (on both boards) Auxiliary output that connects to the Bantam Jacks
• J-4 connects to the Tkb mic XLR connector
• J-5 connects to the external Input XLR connector
• P-11 (on both boards) controls output symmetry, is factory adjusted and should not be touched.
• P-12 is the Level control for the Tbk mic.
• P-13 is the Gain control for the Tbk mic.
599.
600. RETURN TO TABLE OF CONTENTS
601.
602.
603. 10. INPUT MONITORING MODULE (SX-V only)
604.
605. Click here for Picture
606. The 8-Input monitoring module provides monitoring for 8 different external stereo sources.
607. Switches 1 through 8: these switches select the input source, the signals are switched to the monitoring circuit.
608.
609.10.1 Mode switch (upper right corner)