Soundtube CM-EZ-II - Manual (Page 4)

1.435.647.9555 | 800.647.TUBE | www.soundtube.com Pre-construction Install Instructions
CM-EZ-II
CM-EZ-II CM-E CM-EZ-II Z-II
2. Using a screwdriver, push
release pin up to release
cam. Turn clockwise
until threads engage to
lock cam. Properly term-
inate signal wire in ceiling.
3. Remove rubber feet from
cams, allowing room for
pre-construction bracket.
2. Complete finishing work. 4. Set tap to proper setting.
CM-EZ-8 is factory preset
in the 70.7 Volt mode in
the 20 Watt setting .
5. Thread tap & signal wires
thru flexible conduit clamp.
Connect wires with wire
nuts. See tap settings on
front page of this manual
for proper settings.
6. Push connections and
terminated tap wires
into backcan. Push
flexible conduit clamp
into backcan and tighten
clamp onto conduit.
1. Install pre-construction
bracket with lip facing
down. Use nails or screws
to attach to joists.
8. Done! 7. Snap speaker into ceiling.
To Uninstall Speaker
1.
Remove grille and
locate brass release
pins (x4).