Spohn 251 User Manual
Page 2
12. Fully tighten the front and rear mounting hardware. Go over all hardware and make sure everything is
fully tightened.
13. Use a jack to remove the jack stands and then safely lower the vehicle to the ground. Your installation
is complete.
14. The poly bushings come pre-lubed. DO NOT use petroleum-based grease on your poly bushings! Poly
bushings must be lubricated with synthetic silicone based waterproof grease. These are the
manufacturer’s recommendations to prevent pre-mature bushing wear, and will keep things "squeak-
free". You can order this grease from Spohn Performance using our Part #902. Do not over grease the
bushings! You only need a couple pumps of grease. Over greasing will cause the bushings to balloon from
the hydraulic pressure inside of the sleeve and they will fail.
2