Synaps CSD-300 - Manual (Page 6)

Basic Operations
6
2
. Front panel
STANDBY/ON: To switch the receiver power on/stand by
MENUKEY
To enter into the main menu.
VOL<,> KEY: To adjust volume level, or to move cursor left or right in the menu.
CH+,- or^, v KEY : To change channels, or to move cursor up or down in the menu
OK KEY: To see TV/Radio channel list, or to confirm in the menu.
Remote Sensor: Detects infrared signal from remote control unit
Display(4-Digit/7-Segment): Indicates operating status of receiver(optional)
Signal Led: When receiving signal is strong, the signal led is lighted.
3.Rear Panel
Please refer to the diagram above for all possible connections of your receiver
Do not connect the unit to the mains socket until all other connections have been made and checked.
POWER ON/OFF SWITCH: To switch ON/OFF the receiver power supply.
RF OUT: This enables the connection of another receiver.
RF IN: This port is to connect the coaxial cable from Antenua Socket.
ANT IN: Connect to Analog TV antenna.
TV OUT : This is used to connect your TV through RF cable.
TV : This is used to connect your TV through SCART cable.
VIDEO : This RCA connector is used to connect any external video.
0/12V 50mA:This is used to Connect 12V to an external 0V/12V switch.
AUDIO R/L : These RCA connectors are used to connect any external audio amp or system.
RS 232C SERIAL PORT: This is used to connect your receiver to a computer through a serial cable.
USB: Connect to USB disk, you can view *.JPG pictures or upgrade software via this port.
4.Connecting Your System
There are three ways to connect the receiver to your existing TV system. We recommend using one
of the following cases for the best result:
1. Connect one end of SCART cable to the TV (SCART) jack on the back of the receiver and the other
end to a SCART jack on your TV.
2. Connect one end of RCA cable to the RCA jack on the back of the receiver and the other end to a
RCA jack on your TV.
3. If your TV doesn't have a RCA jack, connect one end of RF cable to the TV on the back of the
receiver and the other end to a RF input jack on your TV.