Teac DVW-D13A - Manual (Page 16)

Basic Operation
8 TEAC Tower DVD Duplicator User’s Manual
Basic Operation
This section explains the basic operation of the DVD Duplicator.
Copying from the Optical (DVD) Source Drive
1. Place a source disc in the disc tray of the source drive.
2. Switch to function [1 Copy] by pressing the button (if necessary).
3. Place a blank DVD-R disc into as many of the target drives as you
desire, then press the (ENT) button to start copying.
You do not need to insert a DVD disc into every available target drive. You
can make fewer copies if you prefer. The internal controller will
automatically detect inserted discs and issue the record command to only
those target drives that contain a blank disc.
When the copy operation is complete, the DVD disc in each of the target
drives will be ejected automatically.
Note: The following instructions apply to all DVD Duplicator models.
Note:
❑
With the default setting, after a source disc has been successfully copied, the
DVD Duplicator automatically ejects the target DVD discs.
❑
With the default setting, if the copy operation fails, the failed target DVD disc
remains in the target drive. To remove the failed DVD disc, press the eject
button on the target drive and retrieve the disc. Press the eject button again
to retract the disc tray. You can change the default settings by using the
[Advanced Setup] menu. (For more information, see “12 Advanced Setup
(Adv Setup)” on page 20.)
TEACdvwd17h.book Page 8 Sunday, May 1, 2005 6:28 PM