Teac K-01 - Manual (Page 10)

10
Identifying the Parts (Main Unit)
A POWER
Press this button to turn the unit on and off.
The blue indicator lights when the unit is turned on.
B WORD indicator
Shows word synchronization status.
Blinks when a word clock signal is received.
Lights continuously when a word clock signal is locked.
C MODE (source select)
When playback is stopped, each time the MODE button is
pressed, the source changes as follows:
CD/SACD
COAX (COAXIAL) in
OPT (OPTICAL) in
USB in
When an external input is selected, the unit can be used as a D/A
converter (page 18).
Press and hold this button for more than 2 seconds to enter the
setup mode (page 20).
D Remote control sensor
Receives signals from the remote control unit. Point the remote
control unit at this sensor when operating the remote control.
E Disc tray
C D E J K F G B H I A
F Display
G OPEN/CLOSE
Press this button to open or close the disc tray.
H STOP
Press this button to stop playback.
If you are playing a SACD that allows selectable layer playback,
when playback is stopped, press and hold this button for more
than 2 seconds to change the play area of the SACD disc.
In setup mode, press this button to exit setup mode.
I PLAY
Press this button to start playback.
The indicator ring lights during playback.
J PAUSE
Press this button to pause playback.
The indicator ring blinks during pause mode.
K Skip (.//)
Press these buttons to skip forward and backward.
During playback, press and hold these buttons for more than
1 second to scan forward and backward.
Repeated pressing and holding of these buttons changes the
scanning speed (page 15).
In setup mode, press these buttons to change adjustable settings
(page 20).