Teac P-02 - Manual (Page 20)

20
1
Press the MODE button repeatedly to select an item.
Each time the MODE button is pressed, the item changes as
follows:
UPCONV>
WORD>
CLKIN>
XLR>
RCA> i>
DAC>
LIGHT>
UPC-A> FLaOFF>
LAYER>
LOAD>
< If no button is pressed for more than 10 seconds, the unit will
exit setup mode and return to the previous display.
2
Press the Skip (.//) buttons to change the setting.
See pages 21–24 for details about each setting.
Wait more than 10 seconds or press the STOP button to exit
setup mode and return to the previous display.
< Memorized settings are stored even after the power cord has
been disconnected.
Changing Settings Display Dimming
You can change the brightness of the display and indicators.
Press the DIMMER button to change the brightness.
Each time the DIMMER button is pressed, the brightness changes
as follows:
3 full brightness
2
1
0 off
< When off, if you press a button, the display lights temporarily for
3 seconds.
< When an error message appears or the unit is in setup mode, the
display lights with full brightness.